QMOBILE i6 Metal ONE dump file
EMMC NAME: H8G1e , Vendor: SKHYNIX , S/N: 3282914D , rev. 07
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
Boot from: ROM2 (Boot partition 1) , width: 1 bit
Boot Partition [179] / Bus Config [177] : 0x48 / 0x00
H/W Reset Function [162] : 0x01 , RST_n signal is permanently enabled
Partition setting [PARTITION_SETTING_COMPLETE] : 0x00
EMMC Permanent / Temporary Write Protection : No / No
Compression is ON
Z3X EasyJtag Software ver. 2.9.0.3
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0A0050225B0FD73F, ,FW Ver.: 01.62
CMD Pullup Level:1804 mV
CMD Active Level:2670 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------
EMMC CID : 90014A483847316505073282914D43AA
EMMC CSD : D02701320F5903FFFFFFFFEF8A4040D2
EMMC Manufacturer ID: 0090 , OEM ID: 014A
EMMC Date: 04/2016 Rev.0x7
EMMC NAME: H8G1e , S/N: 847417677
EMMC NAME (HEX): 48384731652000
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.7 (MMC 5.0)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x48.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H8G1e _ 847417677_20180612_1226.extcsd
Partition table scan:
GPT: not present
Done.
No comments:
Post a Comment